Banner SureCross DX80 Wireless Networks - Manual (Page 59)

59
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Sensor Connections
AOx
external
power
GND
SureCross Device
dc common
Analog Outputs
For analog sensors, the ground/dc common of the sensor should be connected to the ground of the DX80 device. For best results, Banner
recommends that the power source for the sensor and DX80 device is the same.
Three-wire analog output device powered
externally (not from the DX80 device).
AOx
PWR
GND
SureCross Device
Three-wire analog output device powered off
the DX80 device.
Drive/Motor
Controller
AOx
GND
AI+
AI−
SureCross Device
When the AI- can be referenced to ground,
use this wiring diagram for drive/motor
controllers.
Drive/motor
controllers
AOx
GND
AI+
AI−
SureCross Device
When the AI- cannot be referenced to ground,
use this wiring diagram for drive/motor
controllers.