Banner SureCross DX80 Wireless Networks - Manual (Page 36)

36
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
SureCross Wireless Network
Product Manual
Advanced Setup
Automatic Binding (Menu Navigation)
The easiest way to bind the Gateway to its Nodes is by triple clicking button 2 to enter automatic binding mode. For these instructions, refer to
the installation and setup instructions in the Installation chapter.
If you would prefer to begin automatic binding mode using the menu structure instead of the buttons, follow these steps:
On the Gateway
1. Remove the Gateway’s top cover.
2. Move DIP switch 1 to the ON position to activate extended addressing mode.
3. Apply power to the Gateway.
The LCD should show POWER, then *RUN.
4. On the Gateway, single click button 1 to advance across the menus, stopping at the DVCFG menu.
5. Single click button 2 to select DVCFG. Single click button 1 to select from the available menu options, stopping at XADR.
6. Single click button 2 to enter XADR mode. When the display reads (AUTO), single click button 2 again to begin the automatic binding
mode.
The LCD shows NETWRK BINDNG and the LEDs flash alternately when the Gateway is in binding mode. Any Node entering binding
mode will bind to this Gateway.
On the Node
7. Remove the Node’s top cover.
8. Move DIP switch 1 to the ON position to activate extended addressing mode.
9. Apply power to the Node.*
The LCD should show POWER, then *RUN.
10. On the Node, single click button 1 to advance across the menus, stopping at the DVCFG menu.
11. Single click button 2 to enter the DVCFG menu.
12. Single click button 1 to select from the available submenu options, stopping at XADR.
13. Single click button 2 to enter the XADR submenu.
14. When the display reads (AUTO), single click button 2 to begin the automatic binding mode.
The LCD shows NETWRK BINDNG to indicate the Node has entered binding mode.
When the Node is bound, the LEDs are both solid red for a few seconds and the LCD shows BOUND. The Node cycles its power, then
enters RUN mode.
15. Use both of the Node’s rotary dials to assign a decimal Device Address between 01 and 48.
The left rotary dial represents the tens digit (0–4) and the right dial represents the ones digit (0–9) of the Device Address.
16. Repeat steps 7 through 16 for each additional Node that needs to communicate to that Gateway.
On the Gateway
17. Single click button 1 or button 2.
When button 1 or 2 is pressed, the Gateway exits binding mode and reboots. When the LCD shows POWER, then *RUN, the Gateway
has entered RUN mode.
* For devices with batteries integrated into the housing, remove the battery for one minute to cycle power to the device. After making any
changes to DIP switch settings, you must cycle power to the device or the DIP switch changes will not be recognized.