Great Plains 2510HDP Operator Manual - Manual (Page 75)

Great Plains Manufacturing, Inc. Table of Contents Index Hydraulic Drive Operation 71
2013-10-21 Table of Contents Index 118-245M
Refer to Figure 73
6.
Press Function key until the Calibration window
appears as shown.
7. Press up arrow key to enter calibration mode.
Refer to Figure 74
8.
This is the first window that appears in Calibration
mode. Press Function key to accept, or Up key to
change to metric settings.
Refer to Figure 75
9.
Enter drill width here using Up/Down arrow keys.
Press Function key to advance to next window.
Refer to Figure 76
10. Enter number of rows here using Up/Down arrow
keys. Press Function key to advance to next window.
Figure 73
Press Up Key to Calibrate
22717
Figure 74
Measurement Mode
22718
Figure 75
Cal. Mode Drill Width
22779
Figure 76
Cal. Mode Row Count
22720