Great Plains 2510HDP Operator Manual User Manual
Page 78
74
1510HDP/2010HDP/2510HDP
Great Plains Manufacturing, Inc.
118-245M
2013-10-21
Refer to Figure 83
18. While the drive is rotating, the display window shows
the time remaining and the “Out” rate.
CONTINUE TO MONITOR DRIVE AREA DURING DRIVE
ROTATION. PRESS THE ENGAGE KEY (OR OFF KEY) TO
STOP DRIVE DURING CALIBRATION
Refer to Figure 84
19. After Calibration meter rotation has ended, this
screen will appear.
Refer to Figure 85
20. Enter the actual amount metered using the Up/Down
arrow keys. Press Function key to advance to next
window.
Refer to Figure 86
21. A New calibration number is suggested, along with
the old calibration number.
Figure 83
Cal. Mode Prompt In Motion
22727
Figure 84
Cal. Mode Normal Completion
22728
Figure 85
Cal. Mode Enter Seed Count
22729
Figure 86
Calibration Number
22730