Dell 3110cn Color Laser Printer - Manual (Page 109)

Select Network Connections from Control Panel. a.
Right-click Wireless Network Connection and select Properties. b.
Select the Wireless Network tab. c.
Click the Advanced button. d.
Select Access point (Infrastructure) networks only and close the Advanced dialog box
(Applicable to printer with the wireless infrastructure mode). e.
Select the setting that you send to the printer in the list in the Preferred Network group f.
Click Move up to move the setting to the top of the list. g.
Click OK to close the Property dialog box. h.
NOTE: When your operating system is earlier than Windows 2000, create settings according to the
manual of the wireless setting tool provided by your wireless device manufacturer.
Access point (Infrastructure, Fixed IP network)
Ensure that the addresses of your computer and access point is in the same IP range. Match the subnet
mask and gateway addresses of your computer to the access point settings. 1.
Create new wireless settings of your computer by following the steps below. 2.
NOTE: If your computer provides a wireless LAN adapter tool, change the wireless settings using this
tool. Or you can change the wireless settings using the tool provided by the operating system. See the
instructions below.
Select Network Connections from Control Panel. a.
Right-click Wireless Network Connection and select Properties. b.
Select the Wireless Networks tab. c.
Make sure the check box for Use Windows to configure my wireless network settings is
checked. d.
NOTE: Be sure to write down the current wireless computer settings in steps d and f so that you can
restore them later.
Click the Advanced button. e.
Select Computer to Computer (ad hoc) networks only and close the Advanced dialog box. f.
Click the Add button to display Wireless network properties. g.
Under the Association tab, enter the following information and click OK. h.