Dell 3110cn Color Laser Printer - Manual (Page 155)

Auto
Automatically selects a tray according to the paper size and type settings of the job being
printed except for the multipurpose feeder.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP*
Used when the communication protocol supports both ASCII and binary data to switch between
them according to the specified control code.
Binary
Used when no special processing is required.
System Settings
Use the System Settings menu to configure the basic printer settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the amount of time the printer waits after a job is printed before it goes into the power saver
mode.
Values:
Mode1 5-60
min
Specifies the amount of time before the printer enters power saver mode after it
finishes a print job.
5 min*
Mode2 1-6 min
6 min*
Enter 5 to put the printer in power saver mode five minutes after it finishes a print job. This uses much less
energy, but requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit
with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready
to print with minimum warm-up time. Select a value between 5 and 60 minutes for power save mode if you