Parallel – Dell 3110cn Color Laser Printer User Manual
Page 153
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings
for the wireless network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto*
Used when auto-detecting the PostScript communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and binary data to switch between
them according to the specified control code.
Binary
Used when no special processing is required.
Parallel
The Parallel menu can be adjusted to configure the parallel interface.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
ECP
Purpose:
To specify the ECP communication mode of the parallel interface. The change becomes effective after the
printer is turned off and then on again.
Values:
Enable*
The ECP communication mode is enabled.
Disable
The ECP communication mode is disabled.
Adobe Protocol