Dell 3110cn Color Laser Printer - Manual (Page 146)

HTTP-SSL/TLS* 1 Enable*
Enables the HTTP-SSL/TLS port.
Disable
Disables the HTTP-SSL/TLS port.
*1 Only displayed when an optional multi protocol card is installed on the printer and the optional wireless
printer adapter is not installed on the card.
IPX/SPX
Purpose:
To configure the IPX/SPX settings for the wired network. The change becomes effective after the printer is
turned off and then on again.
Values:
Auto*
Automatically sets the frame type.
Ethernet II
Uses the Ethernet II frame type.
Ethernet 802.3
Uses the IEEE802.3 frame type.
Ethernet 802.2
Uses the IEEE802.2 frame type.
Ethernet SNAP
Use the SNAP frame type.
NOTE: The IPX/SPX menu is only displayed when an optional multi protocol card is installed on the
printer and the optional wireless printer adapter is not installed on the card.
IP Filter (IPv4)
Purpose:
To specify that data received from certain IP addresses through the wired network is blocked. You can set up
to 5 IP addresses. The change becomes effective after the printer is turned off and then on again.
Values: