Dell 3110cn Color Laser Printer User Manual
Page 144
Gateway Address
Sets the gateway address.
Reset
IPsec*
2
Disables IPsec.
*
1
Only displayed when an optional multi-protocol card is installed on the printer.
*
2
Only displayed when IPsec is enabled.
*
3
This mode is available only when firmware version 200705311601 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the
printer driver is not available when using this mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on
again.
Values:
LPD
Enable*
Enables the LPD port.
Disable
Disables the LPD port.
Port9100
Enable*
Enables the Port9100 port.
Disable
Disables the Port9100 port.
IPP*
1
Enable*
Enables the IPP port.
Disable
Disables the IPP port.
SMB TCP/IP*
1
Enable*
Uses TCP/IP for SMB.
Disable
Does not use TCP/IP for SSB.
SMB NetBEUI*
1
Enable*
Uses NetBEUI for SMB.
Disable
Does not use Net BEUI for SMB.