Sd vflash card, Replacing the sd vflash card, Network daughter card/lom riser card – Dell PowerEdge VRTX User Manual
Page 43: Removing the network daughter card/lom riser card
SD vFlash Card
Replacing The SD vFlash Card
1.
Remove the server module from the enclosure.
2.
If installed, remove the SD vFlash card from the card slot.
NOTE: The SD vFlash card slot is near the Fabric B PCIe mezzanine card slot at the back corner of the server
module.
3.
To install the SD vFlash card, insert the contact-pin end of the SD card into the card slot on the VFlash media unit
with the card label side facing up.
NOTE: The slot is keyed to ensure correct insertion of the card.
4.
Press inward on the card to lock it into the slot.
5.
Install the server module in the enclosure.
Figure 14. Replacing the SD vFlash Card
1. SD vFlash card
2. SD vFlash card slot
Network Daughter Card/LOM Riser Card
Removing The Network Daughter Card/LOM Riser Card
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Remove the server module from the enclosure.
2.
Open the server module.
43