Dell POWEREDGE M1000E - Manual (Page 177)

Fabric OS MIB Reference 159
53-1001768-01
swIPv6ChangeTrap 1.3.6.1.4.1.1588.2.1.1.1.0.7
5
• Successful log in
• Switch configuration changes
• Track changes on and off
This trap gets sent when track-changes is set to ENABLED and is configured to send SNMP traps on
track events. Use the trackchangesset command to enable the track changes feature and SNMP
trap mode.
swIPv6ChangeTrap 1.3.6.1.4.1.1588.2.1.1.1.0.7
Enterprise sw
Variables “swIPv6Address 1.3.6.1.4.1.1588.2.1.1.1.1.29”
“swSsn 1.3.6.1.4.1.1588.2.1.1.1.1.10”
“swVfId 1.3.6.1.4.1.1588.2.1.1.1.2.15”
“swIPv6Status 1.3.6.1.4.1.1588.2.1.1.1.1.30”
This trap is generated when an IPv6 address status change event occurs. It is generated only when
IPv6 stateless state to deprecation state and not for just address change notification.
swPmgrEventTrap 1.3.6.1.4.1.1588.2.1.1.1.0.8
Enterprise sw
Variables “swSsn 1.3.6.1.4.1.1588.2.1.1.1.1.10”
“swPmgrEventType 1.3.6.1.4.1.1588.2.1.1.1.2.12”
“swPmgrEventTime 1.3.6.1.4.1.1588.2.1.1.1.2.13”
“swPmgrEventDescr 1.3.6.1.4.1.1588.2.1.1.1.2.14”
“swVfId 1.3.6.1.4.1.1588.2.1.1.1.2.15”
This trap is generated when any partition manager change happens. This trap is generated when:
• Logical switch is created or deleted.
• Port is moved between logical switches.
• Switch FID changes.
• When any logical switch is changed to base switch.
• VF is enabled or disabled.
swFabricReconfigTrap 1.3.6.1.4.1.1588.2.1.1.1.0.9
Enterprise sw
Variables “swDomainID 1.3.6.1.4.1.1588.2.1.1.1.2.1”
The trap to be sent for tracking fabric reconfiguration. This trap is generated under the following
circumstances: