Ifphysaddress 1.3.6.1.2.1.2.2.1.6, Ifadminstatus 1.3.6.1.2.1.2.2.1.7, Ifoperstatus 1.3.6.1.2.1.2.2.1.8 – Dell POWEREDGE M1000E User Manual
Page 52
34
Fabric OS MIB Reference
53-1001768-01
ifPhysAddress 1.3.6.1.2.1.2.2.1.6
2
ifPhysAddress 1.3.6.1.2.1.2.2.1.6
The interface's address at the protocol layer immediately below the network layer in the protocol
stack.
Values
For interfaces that do not have such an address (for example, a serial line), this object should
contain an octet string of zero length.
•
eth0 returns the MAC address for GbE ports
•
lo returns null
•
SNMP represents the FC port ID in ASCII hex represenation. For example, 36:35:35:33:36 is
equivalent to the decimal value of 65536. To get the decimal value 36-30 = 6; 35-30= 5 and
so. To get the FC port ID, convert the decimal into hex (the hex value of 65536 is 01 00 00,
where the first two digits are the domain, the next two digits are the area, and the last two
digits are the port number).
ASCII hex (36:35:35:33:36) => decimal (65536) => hex (01 00 00)
ifAdminStatus 1.3.6.1.2.1.2.2.1.7
The desired state of the interface.
Values
•
up (1)
•
down (2) or
•
testing (3)
Supports Read only, should return same value with ifOperStatus for WAN and FC ports interfaces.
NOTE
The testing (3) state indicates that no operational packets can be passed. This object is read-only in
Fabric OS v4.x and above.
ifOperStatus 1.3.6.1.2.1.2.2.1.8
The current operational state of the interface.
Values
•
up (1)
•
down (2) or
•
testing (3)
•
unknown (4)
•
dormant (5)
•
notPresent (6)
•
lowerLayerDown (7)
Active tunnels will be up; inactive tunnels will be down (configured but not online).
NOTE
The testing (3) state indicates that no operational packets can be passed.