Dell POWEREDGE M1000E - Manual (Page 181)

Fabric OS MIB Reference 163
53-1001768-01
swAdmStatus 1.3.6.1.4.1.1588.2.1.1.1.1.8
5
swAdmStatus 1.3.6.1.4.1.1588.2.1.1.1.1.8
The desired administrative status of the switch. A management station might place the switch in a
desired state by setting this object accordingly.
Values Possible values are:
• online (1) Set the switch to be accessible by an external FC port.
• offline (2) Set the switch to be inaccessible.
• testing (3) Set the switch to run the built-in test.
• faulty (4) Set the switch to a “soft” faulty condition.
• reboot (5) Set the chassis to reboot in 1 second.
• fastboot (6) Set the chassis to fastboot in 1 second. Fastboot causes the chassis to boot but
omit the POST.
When the switch is in faulty state, only two states can be set: faulty and reboot/fastboot
For the Brocade 3250, 3850, 3900, 8000, 24000, 48000 and DCX director the testing (3) and
faulty (4) values are not applicable.
The possible values for Brocade 300, 5100 and 5300 are either online (1) or offline (2).
swTelnetShellAdmStatus 1.3.6.1.4.1.1588.2.1.1.1.1.9
The desired administrative status of the telnet shell.
Setting this value to 1 (terminated), deletes the current telnet shell task. When this variable
instance is read, it reports the value last set through SNMP.
This OID is supported in Fabric OS v2.x through v3.x.
This OID is not supported in Fabric OS v4.0 through v4.2.
It is supported in Fabric OS version 4.3 and above.
Values Possible values are:
• unknown (0) The status of the current telnet shell task is unknown.
• terminated (1) The current telnet shell task is deleted.
By setting it to 1 (terminated), the current telnet shell task is deleted. When this variable instance is
read, it reports the value last set through SNMP.
swSsn 1.3.6.1.4.1.1588.2.1.1.1.1.10
The soft serial number of the switch.
This variable will return the “ssn” value that is stored in the config database. If the “ssn” key value
pair is not in the config database it will return WWN of the switch.