Dell POWEREDGE M1000E - Manual (Page 267)

Fabric OS MIB Reference 249
53-1001768-01
connUnitPortFCClassCap 1.3.6.1.3.94.1.10.1.4
8
• wan (16)
• ac (17) AC power line. (Not supported in Fabric OS v2.6.1.)
• dc (18) DC power line. (Not supported in Fabric OS v2.6.1.)
• ssa (19) Serial storage architecture. (Not supported in Fabric OS v2.6.1.)
connUnitPortFCClassCap 1.3.6.1.3.94.1.10.1.4
Bit mask that specifies the classes of service capability of this port. If this is not applicable, return
all bits set to 0.
The bits have the following definition:
• unknown 0
• class-f 1
• class-one 2
• class-two 4
• class-three 8
• class-four 16
• class-five 32
• class-six 64
For an F_Port or FL_Port, this value is 0x000C. For a G_Port or E_Port, this value is 0x000D.
For a Brocade Access Gateway, both the F_Port and N_Port this value is 0x0008. An Access
Gateway supports class-three services only, therefore the value is 8 for both port types.
connUnitPortFCClassCap attribute is dependent on the state of the port i.e, whether the port is
online or offline. If the port is offline, the class service of U port will be shown as value of
onnUnitPortFCClassCap. If it is online, then this mib attribute value will be equal to class service
corresponding to the port type (F, E, L port..)
connUnitPortFCClassOp 1.3.6.1.3.94.1.10.1.5
Bit mask that specifies the classes of service that are currently operational. If this is not applicable,
return all bits set to 0. This object has the same definition as connUnitPortFCClassCap.
For an F_Port or FL_Port, this value is 0x000C. For a G_Port or E_Port, this value is 0x000D.
For a Brocade Access Gateway both the F_Port and N_Port this value is 0x0008. A Brocade Access
Gateway supports class-three services only, therefore the value is 8 for both port types.
connUnitPortFCClassOp is independent of the state of the port (online or offline). Its value is only
dependent on the port type.
connUnitPortState 1.3.6.1.3.94.1.10.1.6
The state of the port hardware.
Values Possible values are: