Dell POWEREDGE M1000E - Manual (Page 260)

242 Fabric OS MIB Reference
53-1001768-01
connUnitNumRevs 1.3.6.1.3.94.1.6.1.17
8
connUnitNumRevs 1.3.6.1.3.94.1.6.1.17
The number of revisions in connUnitRevsTable.
Set to 2.
connUnitNumZones 1.3.6.1.3.94.1.6.1.18
Number of zones defined in connUnitZoneTable.
Not supported.
connUnitModuleId 1.3.6.1.3.94.1.6.1.19
This is a unique ID, persistent between boots, that can be used to group a set of connUnits together
into a module. The intended use would be to create a connUnit with a connUnitType of “module” to
represent a physical or logical group of connectivity units. Then the value of the group would be set
to the value of connUnitId for this “container” connUnit.
connUnitModuleId should be 0s if this connUnit is not part of a module.
Set to the WWN of the switch.
connUnitName 1.3.6.1.3.94.1.6.1.20
A display string containing a name for this connectivity unit. This object value should be persistent
between boots.
Set to switchName/sysName.
connUnitInfo 1.3.6.1.3.94.1.6.1.21
A display string containing information about this connectivity unit. This object value should be
persistent between boots.
For a fabric switch set to sysDescr and read-only.
For a Brocade Access Gateway device set to “Access Gateway.”
connUnitControl 1.3.6.1.3.94.1.6.1.22
Controls the addressed connUnit. Each implementation might choose not to allow any or all of
these values on a SET.
Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset.
This is similar to swAdmStatus:
resetConnunitColdStart = reboot
resetConnunitWarmStart = fastboot
offlineConnUnit = disable switch