Dell 5110cn Color Laser Printer - Manual (Page 155)

IP Mode* 1 Dual Stack
Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode
Uses IPv4 to set the IP address.
IPv6 Mode* 3
Uses IPv6 to set the IP address.
IPv4 Get IP
Address AutoIP*
Automatically sets the IP address.
BOOTP
Uses BOOTP to set the IP address.
RARP
Uses RARP to set the IP address.
DHCP
Uses DHCP to set the IP address.
Panel
Enables the IP address entered on the operator panel.
IP Address
Sets the IP address allocated to the printer by using the keys on the
operator panel.
Subnet Mask
Sets the subnet mask.
Gateway Address
Sets the gateway address.
Reset
IPsec*
2
Disables IPsec.
* 1 Only displayed when an optional multi-protocol card is installed on the printer.
* 2 Only displayed when IPsec is enabled.
* 3 This mode is available only when firmware version 200705311932 or later and network (MPC) firmware
version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell
Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the
printer driver is not available when using this mode.
Protocol
Purpose:
To enable or disable each item. The change becomes effective after the printer is turned off and then on
again.
Values: