Dell 5110cn Color Laser Printer User Manual
Page 164
Values:
Filter n
(n is 1 to 5.)
Address
Sets the IP address for Filter n.
Mask
Sets the mask for Filter n.
Mode Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
NOTE:
This item is only available for LPD or Port9100.
Reset MPC
Purpose:
To initialize NVRAM on the multi protocol card.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings
for Network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto*
Used when auto-detecting the PostScript communication protocol.
Standard
Used when the communication protocol is in ASCII interface.
BCP
Used when the communication protocol is in binary format.
TBCP
Used when the communication protocol supports both ASCII and binary data to switch between
them according to the specified control code.
Binary
Used when no special processing is required.