Dell 5110cn Color Laser Printer - Manual (Page 44)

FTP Password Sets whether to enable or disable the password. And also
specifies the password value up to seven characters.
Connection Time-Out Sets the connection timeout period from 1 to 1000 seconds.
IP Filter
(IPv4)*
2
Access List Enter the IP address which is added to the IP filter list.
Subnet Mask Enter the subnet mask.
Operation Select from Disable, Permit, or Reject. Selecting Disable
deactivates the IP filter function. However, selecting Permit (or
Reject) allows (or blocks) the network access from the IP
addresses registered on the IP filter list.
*1 An optional multi protocol card is required to use.
*2 This item is only available for LPD or Port9100.
NetWare
Purpose:
To configure detailed settings for IPX/SPX and NetWare.
Values:
IPX/SPX
Settings Frame
Type Auto Specifies the active frame type automatically.
Ethernet II Selects Ethernet II frame type.
Ethernet
802.3 Selects IEEE802.3 frame type.
Ethernet
802.2 Selects IEEE802.2 frame type.
Ethernet
SNAP Selects SNAP frame type.
Current Frame Type Displays the current frame type.
Network Address Displays the IPX network address.
NetWare Device Name* 1 Specifies the printer name up to 47 alphanumeric characters.
For PServer Mode, set the Print Server Name (Print Server Object
Name). The original setting remains valid if no input is made.
Active
Mode Bindery:
PServer
Mode Selects this option when using Bindery: PServer Mode.