Dell 5110cn Color Laser Printer User Manual
Page 158
Auto*
Automatically sets the frame type.
Ethernet II
Uses the Ethernet II frame type.
Ethernet 802.3
Uses the IEEE802.3 frame type.
Ethernet 802.2
Uses the IEEE802.2 frame type.
Ethernet SNAP
Use the SNAP frame type.
NOTE:
The IPX/SPX menu is only displayed when an optional multi protocol card is installed on the
printer.
IP Filter (IPv4)
Purpose:
To specify the reception of data from certain IP addresses for blocking. You can set up to five IP addresses.
The change becomes effective after the printer is turned off and then on again.
Values:
No.n
(n is 1 to 5.)
Address
Sets the IP address for Filter n.
Mask
Sets the mask for Filter n.
Mode Off*
Disable the IP Filter feature for Filter n.
Accept
Accepts an access from specified IP address.
Reject
Rejects an access from specified IP address.
NOTE:
This item is only available for LPD or Port9100.
Reset LAN
Purpose:
To initialize network data stored in NVRAM.