Dell PowerEdge M600 User Manual
Page 139
Advertising
Installing Blade Components
139
Figure 3-22.
Installing and Removing an HT Bridge Card (PowerEdge M805 Only)
Installing an HT Bridge Card
1 Perform the following steps to prepare the two sockets on the new system
board:
a
Remove the processor filler blank
b
Lift the plastic processor socket cover from the socket.
c
Unlatch and rotate the socket-release lever 90 degrees upward.
d
Lift the processor shield.
e
Repeat steps a through d to prepare the second processor socket.
1
HT bridge card
2
socket-release lever
3
processor shield
4
notch in card
3
1
2
4
Advertising