Dell PowerEdge M600 - Manual (Page 160)

160
Installing Enclosure Components
Figure 4-2. Removing and Installing a Power Supply Module
3 Rotate the power supply module handle down to eject the power supply
module.
4 Slide the power supply module out of the enclosure.
Installing a Power Supply Module
1 Ensure that the power-supply module handle is fully open, and then slide
the power supply module into the enclosure. See Figure 4-2.
2 Rotate the power-supply module handle upward until it latches.
3 Plug a power cable into the power supply module.
1 power supply 2 handle
3 release button
2
1
3