Dell PowerEdge M600 - Manual (Page 167)

Installing Enclosure Components
167
Figure 4-6. Removing and Installing an I/O Module
Installing an I/O Module
NOTICE:
The I/O module must be installed in the appropriate I/O bay. See
"Guidelines for Installing I/O Modules" on page 42.
When installing I/O modules or blanks in the I/O module bays in the back of
our system enclosure, you must install them in right-to-left order:
• A module (or blank) must be installed in bay A2, then bay B2, then bay
C2.
• Next, a module (or blank) must be installed in bay C1, then bay B1, then
bay A1.
1 Unpack the I/O module and prepare it for installation.
For instructions, see the documentation that accompanied the I/O
module.
1 I/O connector cover 2 I/O module
3 release latch 4 handle
2
1
3
4