Dell PowerEdge M600 - Manual (Page 76)

76
About Your System
Unsupported CPU
stepping detected.
Processor is not supported
by the blade. Check for a BIOS update
using the Dell Support
website at support.dell.com.
If the problem persists,
install a supported processor.
See "Processors" on
page 128.
Warning! A fatal
error has caused
system reset.
Please check the
event log for
details.
Unspecified error. Check the system event log
for information about the
error.
Warning! Following
faulty DIMMs are
disabled: DIMM xx ,
DIMM yy .
Faulty or improperly
seated memory modules. See "Troubleshooting Blade
Memory" on page 191.
Warning! No
microcode update
loaded for
processor n .
Unsupported processor. Update the BIOS firmware
using the Dell Support
website at support.dell.com.
Warning: The
current memory
configuration is
not validated.
Change it to the
recommended memory
configuration or
press any key to
continue.
There is no memory
configuration error, but
the memory configuration
is not recommended by
Dell. See "System Memory" on
page 105.
Table 1-18. Blade Messages (continued)
Message Causes Corrective Actions