Dell PowerEdge M600 - Manual (Page 75)

About Your System
75
This system does
not support
processors greater
than 95W.
Unsupported processor(s)
installed. Replace the processor(s)
with a supported version.
See "Processors" on
page 128.
This system only
supports Opteron
2000 series
processors. System
halted.
Unsupported processor(s)
installed. Replace the processor(s)
with a supported version.
See "Processors" on
page 128.
Time-of-day clock
stopped.
Faulty battery; faulty blade
board. See "Troubleshooting Blade
Memory" on page 191. If the
problem persists, see
"Getting Help" on page 217.
Time-of-day not
set — please run
SETUP program.
Incorrect Time or Date
settings; faulty blade board
battery. Check the Time and Date
settings. See "Using the
System Setup Program" on
page 79. If the problem
persists, see
"Troubleshooting the
NVRAM Backup Battery" on
page 195.
Timer chip counter
2 failed.
Faulty blade board. See "Getting Help" on
page 217.
TPM failure A Trusted Platform
Module (TPM) function
has failed. See "Getting Help" on
page 217.
Unsupported CPU
combination.
Mismatched processors are
installed.
Processor is not supported
by the blade.
Replace a microprocessor so
that both microprocessors
match. See "Processors" on
page 128.
Check for a BIOS update
using the Dell Support
website at support.dell.com.
Table 1-18. Blade Messages (continued)
Message Causes Corrective Actions