Salter Brecknell 6700U Series (USB) - Manual (Page 26)

26 67XXU USB/Serial Scale Service Manual
4.3 Navigating the Weigh Mode
4.3.1 Enter the Weigh Mode
Press the [HOLD] + [UNIT] keys for 3 seconds. Use the [UNIT] key to choose the
desired mode and the [TARE] key to confirm selection and exit to the chosen mode.
4.3.2 Enter or Exit the HOLD Mode
Press the [HOLD] key for 3 seconds.
4.3.3 Zero
When the weight is stable and within the zero range, press the [ZERO] key to set a new
zero point. Refer to
Table 4.3 for zero limitations.
4.3.4 Tare
When the gross weight is larger than zero and the scale is stable, press the [TARE]
key. The indicator will show a net weight of zero and the NET annunciator will be
illuminated. Refer to
Table 4.3 for tare limitations.
4.3.5 Preset Tare Weight
Enter a preset tare weight by pressing the [TARE] key for more than 3 seconds.
Pr.Tar will be displayed and the NET annunciator flashes. Use the [UNIT] and
[TARE] key to input the desired tare weight and the [HOLD] key to move to the next
digit. The value entered must be larger than zero and there is no limitation to preset
tare weight. After the tare weight is entered the NET annunciator will illuminate. Refer
to
Table 4.3 for tare limitations.
Note: This indicator can only save one tare weight. The new tare weight will
automatically replace the old one.
4.3.6 Clear Tare Weight
Remove any weight on platform and wait until the scale is stable. Press the [TARE] key.
Table 4.3 Zero and Tare Limitations
Standard
Weight on
platform
Data in TARE
memory unit
key function
Tare key Zero key
USA ≤0 no No action Zero
yes Clear the tared weight
>0 no Tare
yes