Salter Brecknell 6115 - Manual (Page 12)

The TEST key menu allows access to the following
features: UNDO O, SENSOR (if equipped-See
SENSOR feature in the CONF Menu Mode),TEST,
DONE.
When in normal operation, press the TEST key…
“UNDO 0” is displayed.
Press the TEST key again to re-establish the previ-
ous weight value due to an inadvertent zero func-
tion. The last established zero value is restored.
This feature is most likely useful when the unit is
equipped with the zero photoeye mechanism and
it was triggered by accident while performing a
portion-weighing step. The scale will then return
to the normal operation.
Or press ZERO and…
“SENSOR” is displayed. (Only on equipped
models.)
From this routine you can adjust the sensitivity, view
the current sensitivity value, turn off the photoeye,
or turn on the photoeye (if previously turned off
manually). Refer to the details about the sensor
settings in the CONF Menu mode.
Or press ZERO and…
“TEST” is displayed.
To perform a display test, press the TEST key again.
The display will automatically scroll through a se-
ries of messages including the scale model num-
ber “61—,””””” program revision “01-01” (example), the
sensor status “SEN-X” if so equipped, and then
perform a countdown display test. The unit will
then return to the normal operation.
Or press ZERO and…
“DONE” is displayed.
Test Key Menu
9