Salter Brecknell 6115 - Manual (Page 8)

8. Verify that the power cable (round end) is
plugged into the scale power input connector,
then plug the line cord adapter into an appro-
priate, properly grounded voltage outlet.
9. The scale is now ready for operation.
Scale Min. Cut-Out
Model Dimensions Dimensions
6103 6 x 10 in 6.25 x 10.25 in
(159 x 260.5 mm)
6112 10 x 10 in 10.25 x 10.25 in
(260.5 x 260.5 mm)
6115 13 x 13 in 13.25 x 13.25 in
(336.5 x 336.5 mm)
Cut out dimensions not applicable when scale has
attached display bracket. Contact factory for out-
line dimensional drawing if necessary.
See Figure 1 to determine how to install the dis-
play bracket if supplied.
Cut Out Dimensions
Installing
Display Brackets
Figure 1
5
Place bracket over leveling foot and slide securely into place as
shown below.
Example: 6112/6115 with rear, flat or pole bracket.