Salter Brecknell 6115 - Manual (Page 26)

3. DO NOT submerge the scale base or display in
water.
4. DO NOT use acetone or other solvents to clean
the scale.
5. DO NOT expose to extreme temperatures or
excessive moisture.
6. CLEAN the display with a soft cloth dampened
with a mild detergent.
7. REMOVE THE PLATTER and clean with a mild
detergent.
8. If supplied with a rear post display, remove
bracket from the scale and clean with the bristle
brush supplied.
Should you experience any problem with your scale,
please contact your nearest scale dealer, or the
Weigh-Tronix Service Department.
Perform the following steps in the order presented
until the described problem is corrected.
No Power (Display is Blank)
1. Check that the primary side of the cord is
plugged into the AC outlet, and the secondary
side is properly connected to the power jack on
the back of the scale.
2. Replace the power supply.
3. Replace the display board.
4. Replace the main board.
Symptom and
Recommended Action
Troubleshooting
23