Salter Brecknell 6115 - Manual (Page 16)

The Diagnostic (DIAG) Mode menu lets you test
specific areas of the unit’s function.
The items in the Diagnostics menu are as follows:
Display (DISP) – Shows the version and revision of
the software, display type, sensor setting (if
equipped), followed by a display segment test.
Input/Output (I/O) – Allows testing of the scale COM
port. Data is output from the transmit port and
through the use of a loopback connector into the
receive port, the data is immediately read back
and verified against what was sent. “PASS” or
“FAIL” is displayed. Requires jumper (short)
between transmit and receive data lines.
Internal Counts (A/D) – Displays A/D data. Factory
use only.
Follow these steps to access the tests in the DIAG
Menu
From normal weighing mode, press SW-1…
“DIAG” is displayed.
Press the TEST key.
“DISP” is displayed.
Press the TEST key to perform the display test as
described earlier. The display test is performed
and shows “DISP” after the test is completed.
Step-by-Step
Instructions for
DIAG Mode
Press the ZERO key to
scroll through or skip
a test selection.
Press the TEST key
to perform a test.
Display Test
13
Diagnostics Mode