Detex DTX-4300 - Manual (Page 19)

Chapter 2: Installation
Chapter 2 supplies information about prox.pad plus
installation configurations; installation considerations;
and procedures for checking the cables, mounting the
prox.pad plus unit, inserting circuit boards, and de-
faulting prox.pad plus memory.
2.1 Installation
Configurations
It is the installer’s responsibility to determine the ap-
propriate prox.pad plus installation configuration,
which differs from installation to installation. These
three installation configurations are possible:
• Wall mounted installation (exterior to the room
to be accessed). In this configuration, a single gang
electrical box can be used. Typically, the prox.pad
plus unit is wall mounted (surface mounted) out-
side the access area on the unsecured side.
• Glass mounted installation, using the four IEI-
supplied pressure-sensitive adhesive pads. In this
configuration, the prox.pad plus unit is affixed
with the adhesive pads to the glass door or the
window adjacent to the door being accessed, on
the interior side of the glass. The side cut-out on
the unit is used to bring the wires out of the side
of the prox.pad plus case.
• Secure installation (or “two-stage” configuration),
for higher security. In this configuration, the
prox.pad plus antenna is located a maximum of
10 feet away from the controller/keypad; the con-
troller/keypad is located on the secure side of the
door.
prox.pad plus Install/Program. Manual, PPP, D4b 2-1
Part No. 6105679, Rev. 1.1