Detex DTX-4300 - Manual (Page 63)

4.2.2.B Quick Program Feature
A “quick program” feature has been implemented for
user data, however. You only need to enter the user’s
location and the keypad PIN (or present card), in the
format noted below. Employing the quick feature auto-
matically selects a “Normal” user access type.
user location # new code * repeat code
OR
user location # ** <present card>
4.2.2.C Programming Code ONLY Use
You can program a user Code ONLY use with com-
mand 50. The program sequence is as follows:
50 # user-type # user location #
new code * repeat code *
4.2.2.D Programming Code AND Card Use
The format for programming a user for both Code
AND Card use is as follows:
50 # user-type # user location #
new code * repeat code * <present card>
When a combination code/card user employs the
prox.pad plus unit, that user can present the proximity
card first at the proximity reader, or enter the code
first at the prox.pad plus keypad as desired.
After the code/card user either presents the card at the
reader or enters the code on the keypad, the red and
green LEDs alternate. This indicates that the unit is
awaiting the second part of the transaction before
granting access. After the second part of the transaction
is completed successfully, the bi-color LED turns solid
green and the door opens.
4.2 Programming Users Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D4b 4-11
Part No. 6105679, Rev. 1.1