Spool pins horizontal spool pin, Presser foot lifter, Vertical spool pin – SINGER S800 FASHIONISTA User Manual
Page 14: Feed dog control
12
SPOOL PINS
HORIZONTAL SPOOL PIN
Place thread spool on the pin and secure with a spool cap to
HQVXUHVPRRWKÀRZRIWKUHDG,IWKHWKUHDGVSRROKDVDWKUHDG
retaining slit, it should be placed to the right.
Select the correct spool pin cap according to the type and
diameter of spool being used. The diameter of the spool pin
cap should always be larger than that of the spool itself.
PRESSER FOOT LIFTER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric, and to change presser foot.
3. Lift it to its highest position to accommodate thicker fabrics.
VERTICAL SPOOL PIN
Attach the spool pin and place a felt disc over it. Place a spool
of thread on the spool pin.
Spool pin cap
&RXYUH¿O
Tapa del pasador carrete
Spool
Bobine
Carrete
Spool pin
Porte-bobine
Pasador carrete
Vertical spool pin
Porte-bobine vertical
Pasador de carrete vertical
Spool
Bobine
Carrete
Thread retaining slot
)HQWHGHUHWHQXHGH¿O
Ranura de retención de hilo
Spool pin felt discs
Rondelle feutre
Disco del pasador carrete
FEED DOG CONTROL
The feed dogs control the movement of the fabric that is
being sewn. They should be raised for all general sewing
purposes and lowered for darning, freehand embroidery and
monogramming so that you, not the feed dogs, are moving the
fabric.
Lower the feed dogs by removing the extension table and then
pushing the feed dog lever toward the machine.
To re-engage the feed dogs, push the lever back to the right.
Then, turn the hand wheel toward you one full revolution. You
will see the feed dogs raise back up.
Down
Basse
Abajo
Feed dog lever
Levier de contrôle des griffes
Control de dientes