SINGER S800 FASHIONISTA - Manual (Page 84)

82
FLOWER STITCH ATTACHMENT
*Optional Purchase
7KLVDWWDFKPHQWSURYLGHVDYDULHW\RIÀRZHUSDWWHUQV
1. Before securing the attachment, raise the needle to its
highest position by turning the hand wheel toward you.
2. Drop the feed dogs using the lever located on the back of
the machine after you remove the extension table.
3. Remove the current presser foot and shank.
4. To attach the Flower Stitch Attachment, raise lever (A) so
that it sits above the needle screw (D) and then wrap the
fork (B) around the presser bar. Tighten thumb screw (C).
5. Select the zigzag stitch or blind hem stitch. Set the upper
thread tension to 1-2 and the stitch width to the desired
width.
6. To place fabric under the attachment, position the center
of the intended pattern to center of disc (F). Loosen the
VFUHZ (  0RYH WKH GLVF )  LQ WKH GLUHFWLRQ RU   RU
(-) and set the setting mark (G) at the desired position.
Tighten the screw (E).
7. Hold the end of the needle thread with your left hand. Turn
the hand wheel toward you slowly until the needle moves
down and up again to the highest position, then stop the
hand wheel. Pull the needle thread slowly so that the
bobbin thread can pull through fabric to topside of fabric.
8. While holding the needle and bobbin threads, sew a few
stitches to lock threads. Cut threads near the seam end
and sew.
9. At the end of a seam, raise needle to its highest position
and lift the presser foot lifter. Remove fabric from machine.
10. Cut threads, leaving about 15 cm (6 in) of thread. Tie off
thread ends at back of fabric.