SINGER S800 FASHIONISTA - Manual (Page 22)

20
4
3
B. Turn the hand wheel toward you until the needle is in its
highest position.
&7KUHDGWKHPDFKLQHZLWK\RXUOHIWKDQGZKLOH¿UPO\JULSSLQJ
the thread with your right hand in the following order as
illustrated.
* Guide the thread through thread guide (1), and then pull
it into the pre-tension guide (2).
* Pull the thread into the tension discs (which are located
LQVLGHWKHPDFKLQH E\¿UVWSDVVLQJWKHWKUHDGWRWKHOHIW
of plate (2). Then guide the thread to the bottom of the
groove.
* Do a U-turn around the inside of the tab (3).
* Pass the thread through the thread take-up (4) from right
to left.
* Pull the thread into the inside of the take-up lever until it
reaches the eye of the lever.
* Guide the thread into the thread guide (5).
* Pass the thread through the eye of the needle (6) from
front to back. (See following page for instructions on
operation of the Automatic Needle Threader.)
THREADING THE TOP THREAD
A. Raise the presser foot lifter. Always be sure to raise the
presser foot lifter before threading the top thread.
IMPORTANT:
To verify that the machine is threaded
properly in the tension discs, do this simple
check:
1.) With the presser foot raised and the
needle unthreaded, pull the thread. You
should detect only a slight resistance
DQGOLWWOHRUQRGHÀHFWLRQRIWKHQHHGOH
2.) Now lower the presser foot and again
pull the thread towards the the back
of the machine. This time you should
d e t e c t a c o n s i d e r a b l e a m o u n t o f
resistance and much more deflection
of the needle. If you do not detect the
resistance, this means you have not
threaded the machine correctly and
need to rethread it.
If the presser foot lifter is not raised, correct thread
tension cannot be obtained.