Accessoires, Removing and replacing bobbin case, Accesorios – SINGER 2866 User Manual
Page 17: Replacing the bobbin case to remove bobbin case
78
15
Faites
connaissance
de votre machine
Conozca
su
máquina
Accesorios
Accessoires
Los siguientes accesorios, suministrados con su máquina
de coser, están diseñados para simplificar sus proyectos
de costura y aumentar la versatilidad de su máquina.
Les accessoires suivants sont fournis avec votre machine
pour faciliter la couture et augmenter les possibilités de
votre machine.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
4.
5.
6.
7.
8
9.
Placa cubre impelentes
Prensatelas de uso especial para bordado (J)
Prensatelas para ojales (L)
Prendedor para porta carretel
Prensatelas para cremalleras (E)
Prensatelas para puntada invisible
Paquete con agujas de varios tamaños
Prendedor para la bobina
Bobinas (3 unidades)
Couvre-griffes
Pied bourdon (J) pour des points décoratifs
Pied boutonnière (L)
Grand étrier: pour maintenir en place les bobines
sur le porte-bobine.
Pied ganseur (E): pour poser des fermetures
glissières
Pied point caché, pour la couture d'ourlets au
point caché
Assortiment d'aiguilles de différentes grosseurs
Aiguille jumellée
Petit étrier: pour bloquer les fusettes ou petites
bobines
Bobines (3 unités)
Functions
of the
machine
Removing and
replacing bobbin case
1. Raise the presser bar and remove the needle, needle
plate and bobbin.
2. With a small screwdriver, turn and take hold of the
bobbin case retaining plate to the rear as far as it will
go (illustration 2).
3. Lift the left side of the bobbin case and slide it out to
the left and out from the machine (illustration 1).
4. Loosen slightly the bobbin case retaining plate until its
initial position (illustration 4).
Replacing the bobbin case
To remove bobbin case
1. With a small screwdriver, the bobbin case retaining
plate to the back as far as it will go (illustration 2).
2. Draw rim (A) of bobbin case under the feed (C).
3. Draw rim (B) of bobbin case under position plate (D).
Be sure bobbin case is freely seated on hook race.
4. Turn the bobbin case retaining plate back to its
original position (illustration 4).
5. Replace needle plate.
6. Insert bobbin, the needle and close the slide plate.
1
C
3
4
B
A
2