CANOGA PERKINS 9145E NID Software Version 3.1 - Manual (Page 115)

9145E NID Software User’s Manual Link OAM
OAM Control
100
9.1 OAM Control
From the Link OAM screen, select OAM Control (1) and press Enter. The OAM Control (Figure
9-2Figure 9-2) opens.
The OAM Control screen has two sections. The top of the screen shows status information. The
bottom of the screen allows you to control the OAM settings and displays configuration
parameters. Each screen contains Link OAM status and configuration for two ports. To navigate
to different ports, use the (N)ext and (P)revious commands. Press Esc to return to the Link OAM
menu.
The standard configuration parameters and their corresponding MIB objects are listed in the
section “User Interface MIB Objects”.
Figure 9-2 The OAM Control screen
9.1.1 OAM Operational Status
At initialization and failure conditions, two OAM entities on the same full-duplex Ethernet link
begin a discovery phase to determine what OAM capabilities may be used on that link. The
following is the list of possible values:
Disabled Returned if OAM is disabled on this interface via the OAM Admin State.
Canoga Perkins Corp. Ethernet Network Interface Device 01-JAN-2009
9145E-101-1-0 V03.10(GA0014) 03:09:44
----------------------------------------OAM CONTROL----------------------------
User Port Network Port
--------- --------------
OAM Operational Status Link Fault Disabled
OAM Max PDU Size 1518 1518
OAM Revision 1 1
OAM Functions Supported Unidirectional Unidirectional
Loopback Loopback
Link Events Link Events
OAM Loopback Status No Loopback No Loopback
OAM Remote Link Fault No No
1) OAM Admin State Enabled Disabled
2) OAM Mode Passive Active
3) OAM Loopback Command No Loopback No Loopback
4) Process Rx Loopback OAMPDU No No
5) Process Rx Link Fault Flag Yes Yes
6) Fwd Critical Event No No
Select [1-6]:
------------------------------------Messages-----------------------------------