CANOGA PERKINS 9145E NID Software Version 3.1 - Manual (Page 111)

9145E NID Software User’s Manual Software Upgrade
Software Upgrades Using FTP or SFTP
96
8.5 Software Upgrades Using FTP or SFTP
8.5.1 Software Download using FTP
Software upgrades can also be downloaded from the Canoga Perkins web site and installed
using the computer that is the 9145E management host.
1. Go to the Canoga Perkins web site or contact Canoga Perkins Customer Service to obtain the
latest version of the 9145E software and copy the file to the 9145E management host.
2. Open a Command Prompt by selecting Start > Run
3. Type CMD into the OPEN window and click OK. The Command Prompt screen opens (Figure 8-
3).
Figure 8-3 Command Prompt screen
NOTE: Confirm that the IP address of your computer is listed in the 9145E host
table. If not, you cannot access the 9145E. To add the computer IP
address in the host table, see the section “Host Table” on page 15.
4. If required, type cd directory name.
Where directory name is the name of the directory where the software upgrade is
located.
5. Press Enter. The prompt will be relocated to that directory.
6. At the directory prompt, type ftp IP address.
Where IP address is the management IP address for the 9145E.
7. Press Enter. Service will be established.
Microsoft Windows XP [Version 5.1.2600]
(C) Copyright 1985-2001 Microsoft Corp.
C:\>cd Documents and Settings
C:\Documents and Settings>ftp 172.16.142.223
Connected to 172.16.142.223.
220 Service ready for new user.
User (172.16.142.223:(none)): admin
331 Username okay, need password.
Password:
230 User logged in, proceed.
ftp> cd BURNING
250 Requested file action okay, completed.
ftp> BI
200 Command Okay.
ftp> put 9145e-a10-02-00.zip
200 Command Okay.
150 File status okay; about to open data connection.
226-Closing data connection.
Writing file to flash.
226
ftp: 3415561 bytes sent in 126.42Seconds 27.02Kbytes/sec.
ftp>