2 create a maintenance intermediate point, Create a maintenance intermediate point – CANOGA PERKINS 9145E NID Software Version 3.1 User Manual
Page 176
Service OAM
9145E NID Software User’s Manual
Maintenance Intermediate Points
161
11.7.2 Create a Maintenance Intermediate Point
1. On the Maintenance Intermediate Point List screen (Figure 11-32), type A and press Enter. You
are prompted to enter A for 802.1ag or Y for Y.1731.
2. Type A or Y and press Enter. The Create a New Maintenance Intermediate Point screen (Figure
11-33 for 802.1ag or Figure 11-34 for Y.1731) opens. The MD/MEG ID field is highlighted.
3. Type an MD ID (for 802.1ag) or MEG ID (for Y.1731) and press Enter. (To view a list of MD/MEGs,
press CTRL-L, type S to select, and press Enter). The MIP ID field is highlighted.
4. Type a MIP ID and press Enter. The Admin Status field is highlighted.
5. In the Admin status field, select Enabled or Disabled and press Enter. The Port field is highlighted.
6. In the Port field, select User or Network and press Enter.
7. To accept the new Maintenance Intermediate Point settings, type A and press Enter. The
Maintenance Intermediate Point Attributes screen (Figure 11-35 for 802.1ag or Figure 11-36 for
Y.1731) opens.
8. To modify an attribute value, type the number of the attribute and press Enter, or press Esc to
return to return to the Maintenance Intermediate Point List screen.
Figure 11-34 Create a New Maintenance Intermediate Point screen (802.1ag)
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
9145E-101-1-0 V03.10(GA0014) 05:15:27
-----------------CREATE A NEW MAINTENANCE INTERMEDIATE POINT--------------------
1) MD ID 0
2) MIP ID: 0
3) Admin status: Disabled
4) Port: User
Enter number in range 1 - 65535, or (CTRL-L) to select from list.
------------------------------------Messages-----------------------------------