STIEBEL ELTRON SOM 10 - Manual (Page 10)

en
10
Values and adjustments can be changed in different
ways:
Numeric values can be adjusted by means of a slide
bar. The minimum value is indicated to the left, the ma-
ximum value to the right. The large number above the
slide bar indicates the current adjustment. By pressing
buttons
or 4 the upper slide bar can be moved
to the left or to the right.
Only after the adjustment has been confirmed by
pressing button
5 will the number below the sli-
de bar indicate the new value. The new value will be
saved if it is confirmed by pressing button
5 again.
current value saved minimum value maximum value
adjusted value
(not yet confirmed)
adjustment channel
When two values are locked against each other, they
will display a reduced adjustment range depending on
the adjustment of the respective other value.
In this case, the active area of the slide bar is shor-
tened, the inactive area is indicated as a dotted line.
The indication of the minimum and maximum values
will adapt to the reduction.
active area inactive area
If only one item of several can be selected, they will
be indicated with "radio buttons". When one item has
been selected, the radio button in front of it is filled.
If more than one item of several can be selected, they
will be indicated with checkboxes. When an item has
been selected, an x appears inside the checkbox.
The time frames for the timer can be adjusted in steps
of 15 minutes on a time line.
The cursor can be moved along the time line by
pressing buttons
or 4 . The beginning of a time
frame can be determined by pressing button 1 .
The end of a time frame can be determined by pres-
sing button
3 .