KEYENCE DL-EP1 - Manual (Page 86)

- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (IB) -
3-4 Message Communication
3-56
3
C
om
m
uni
ca
tin
g
w
ith
IB
S
er
ie
s
0305H
(773)
Initial reset request
Initializes all the settings other than the calibration, ref.
light quantity registration, and system parameters of the
sensor amplifier.
All parameters are stored in nonvolatile memory
(EEPROM) approx. 3 minutes after the initial reset
request is executed. After the initial reset request has
been executed, "EEPROM write result" of the attribute for
IB Series becomes normal end (1).
0306H
(774)
System parameter set request
Changes the contents of the system parameter (settings of
judgement output, check output polarity, and analog output)
to the contents written in "system parameter" of the attribute
for the IB Series.
When executing the system parameter set, change the
contents tailored to the connected devices and wiring. If
the contents are changed by mistake, the devices
connected to the sensor amplifier may go down.
030AH
(778)
Ref. light registration request Registers the ref. light quantity.
030BH
(779)
Adjust request
Executes the adjust function.
Turning off the sensor amplifier after executing the adjust
function restores the state before the adjust function is
executed. If the adjust value is retained even after the
sensor amplifier is turned off, set the adjust status storage
function to ON.
030CH
(780)
Adjust reset request Initializes the adjust value.
030EH
(782)
Tolerance tuning request
Executes tolerance tuning.
Set the tolerance setting width using the attribute for IB
Series "tolerance setting width".
030FH
(783)
2-point tuning HIGH side 1st
req
Executes 2-point tuning.
For details on the two-point tuning execution procedure,
refer to "IB Series User's Manual".
0310H
(784)
2-point tuning HIGH side
2nd req (Determine HIGH
setting value.)
0311H
(785)
2-point tuning LOW side 1st
req
0312H
(786)
2-point tuning LOW side
2nd req
(Determine LOW setting
value)
0313H
(787)
Measured correction 1st
req
(SET1 confirmation
operation)
Executes measured correction.
Set the R.V. value that you want to display in the attribute
for the IB Series "Measured Correction/Theoretical
Correction 1st Point Target Value" or "Measured
Correction/Theoretical Correction 2nd Point Target Value".
For details on the measured correction execution
procedure, refer to "IB Series User's Manual". *2, *4
0314H
(788)
Measured correction 2nd
req
(SET2 confirmation
operation)
Attribute
ID
Name Description