KEYENCE DL-EP1 User Manual
Page 87
3-4 Message Communication
3-57
3
C
om
m
uni
ca
tin
g
w
ith
IB
S
er
ie
s
- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (IB) -
*2 To execute measured correction, set the calibration function (036BH(875)) to "1.
Measured correction".
When executing measured correction, set measured correction 1st-point target
value (036CH(876)) and measured correction 2nd-point target value036DH(877))
and then execute the measured correction execution request (operation
command, 0313H(787)), 0314H788.
*3 To execute measured correction, set the calibration function (036BH(875)) to "2.
Measured correction".
When executing logical correction, set logical correction 1st target value
(036CH(876)), logical correction 2nd target value (036DH(877)), logical
correction 1st measurement value (0373H(883)), and logical correction 2nd
measurement value (0374H(884)) and then execute the logical correction
execution request (operation command (031AH(794), 031BH(795)).
*4 Executing other settings in the middle of the 1st- or 2nd-point target or
measurement value makes it impossible to complete calibration setting. Be sure
to set the 1st- and 2nd-point target or measurement values continuously.
• Commands
031AH
(794)
Logical correction 1st req
(SET1 confirmation
operation)
Executes logical correction.
Set the R.V. value that you want to correct in the attribute
for IB Series "logical correction 1st point measurement
value" or "logical correction 2nd point measurement
value".
Set the R.V. value that you want to display in the attribute
for the IB Series "Measured Correction/Logical Correction
1st Point Target Value" or "Measured Correction/
Theoretical Correction 2nd Point Target Value".
For details on the measured correction execution
procedure, refer to "IB Series User's Manual".
*3, *4
031BH
(795)
Logical correction 2nd req
(SET2 confirmation
operation)
Item
Description
Data Example
Service Code
Designates the "operation command (4BH)" (fixed
value).
4BH
Class ID
Designates DL Object (67H)(fixed value).
67H
Instance ID
Designates the ID number. The ID number (00H) of the
DL-EP1 cannot be designated.
08H
Attribute ID
Designates the attribute ID to be designated from
"Attribute".
"(3) Issuing operation commands to a
sensor amplifier" "Attribute IDs supported by the
instance service 4BH (operation command)" (Page 3-
0301H(769)
Service Data
There is no service response data.
-
Attribute
ID
Name
Description