Toa NX-100S Installation - Manual (Page 101)

5-13
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
9. SETTING THE GROUP BUTTON CONTENTS
The Group button is used to simultaneously select two or more Selection buttons. Program the desired
Selection buttons into the Group button.
Step 1. Click on the Group button tab on the Button Setting screen ( p. 5-8 ).
The following initial Group button setting screen is displayed.
(1) (2) (3)
[Registration Contents List]
(1) Enable
Displays or hides the Group buttons.
(2) No.
Group button numbers. These numbers cannot be
changed.
The buttons are arranged in the order of the
button number (see figure at right) on the
operation screen.
(3) Indication Name
The name of the Group button to be displayed on
the operation screen.
Group button layout
(Example when 1 horizontal by
10 vertical buttons are set.)
Step 2. Click off the checkbox ticks in the Registration Contents List for Group buttons not to be used on the
operation screen.
Buttons not marked with a tick are not displayed on the operation screen.