Toa NX-100S Installation - Manual (Page 43)

3-17
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
[Start port No.]
Enter the base number of the TCP port (other than web server, which is used by the unit). The default is
"5000." Enter the number from within the range of 1 – 65532.
The TCP ports are assigned as follows:
Port
Web server
Broadcast control
PC control
Contact bridge
Serial bridge
Port No.
Web server
Start port No. + 0
Start port No. + 1
Start port No. + 2
Start port No. + 3
Protocol
TCP
TCP
TCP
TCP
TCP
Default
80
5000
5001
5002
5003
(3) UDP port number assignment
Designate the base port number to be used by UDP.
[Start port No.]
Enter the base UDP port number to be used by the unit. The default is "5000." Enter an even number from
within the range of 1 – 65526.
The UDP ports are assigned as follows:
Port
Streaming
Error correction
Resend
Serial bridge
Fs* correction
Port No.
Start port No. + 0
Start port No. + 2
Start port No. + 4
Start port No. + 6
Start port No. + 7
Protocol
UDP
UDP
UDP
UDP
UDP
Default
5000
5002
5004
5006
5007
* Sampling frequency
Caution
Since UDP port No. 15000 is used by the unit, numbers between 14990 and 15000 cannot be used.