Toa NX-100S Installation - Manual (Page 96)

5-8
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
7. EDITTING THE BUTTON LAYOUT
The Start button can be set to enable or disable, and the layout of the Selection and Group buttons can be
edited.
Step 1. Start the Operation program and select [Setting] → [Button setting].
The User Authentication screen is displayed.
Step 2. Enter the system name and the password (the same system name and password entered in the setup
program), then press the OK button.
Notes
• Both the system name and the password are case-sensitive.
• The default system name is preset to "NX-100" and the password to "guest" when the unit is
shipped from the factory. To change, refer to p. 3-31 or p. 4-28 .
The Button Setting screen is displayed if the system name and the password have been correctly
entered.