Toa NX-100S Installation - Manual (Page 66)

4-9
Chapter 4: SYSTEM SETTINGS (SETTING USING BROWSER)
5. BROADCAST PATTERN SETTING
The broadcast pattern is determined by the combination of broadcast direction and the units targeted to
receive or transmit the broadcast, and is set in the unit that initiates the broadcast. The pattern then starts the
broadcast when a contact or program operation input is received. Local broadcasts which do not use the
network or single stream broadcasts can also be set as broadcast patterns. (Target receiving unit: 1; Target
unicast transmission unit: 1; Target multicast transmission units: 64)
Create a new broadcast pattern by clicking on the Pattern Addition button, or select and edit a pattern which
has already been programmed.
This figure represents the NX-100.
Pattern Selection Area
Pattern Edit Area