Toa NX-100S Installation - Manual (Page 47)

3-21
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
Step 2. Press the Add button.
The edit area becomes available for editing. Up to 20 patters can be set for each unit.
Step 3. Enter a broadcast pattern name.
Caution
Avoid assigning a name already programmed.
Step 4. Select the broadcasting direction from [Transmission], [Reception], and [Local].
Transmission: Transmits broadcast signals to the connected NX-100 and NX-100S units.
Reception:
Receives broadcast signals from the connected NX-100 and NX-100S units.
Local: Makes broadcasts from the Audio Input of the NX-100 or NX-100S unit to its Audio
Output.
Selecting [Transmission] or [Reception] permits selection of the connected unit.
Caution
[Local] broadcasts cannot be made when the transmission sampling frequency is set to 32 kHz in the
Broadcast Spec setting.
Step 5. Select the connected unit from the displayed list (when [Transmission] or [Reception] is selected)
Cautions
• Only those units connected to the LAN can be selected.
• Only one location can be selected when the multicast function is not used. (Also one location for
reception.)
• Only units designated for multicast streaming can be group-selected.