Toa NX-100S Installation - Manual (Page 38)

3-12
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
5.7. Subnet Mask and Default Gateway Settings
The same subnet mask and default gateway numbers can be set for all selected units.
Step 1. Tick the selection checkbox to select the unit.
To select all units, select [Scan] → [Select all].
Step 2. Set the subnet mask.
2-1. Select [Scan] → [Subnet mask setting].
2-2. A dialog will be displayed. Enter the setting value and click on the OK button.
Step 3. Set the default gateway.
2-1. Select [Scan] → [Default gateway setting].
2-2. A dialog will be displayed. Enter the setting value and click on the OK button.