Toa NX-100S Installation - Manual (Page 34)

3-8
Chapter 3: SYSTEM SETTINGS (NX-100 SETUP PROGRAM)
5. UNIT SCANNING TOOL
Scans the units connected to the LAN.
Setting data can only be uploaded into the NX-100S and NX-100 units after each unit's IP address has been
correctly set by way of either the Installation Setting Program's Unit Scanning Tool or a browser.
5.1. Screen Description
Click on [Unit Scan (Network Setting)] on the initial screen.
Shown below is an example of the screen displayed after the units have been scanned.
(1) Scanned unit list
A list showing the units scanned.
(2) MAC address
Displays the MAC addresses of the units
scanned.
Cannot be changed.
(3) Unit type
Displays either type of unit NX-100 or NX-100S.
(4) IP address
Displays the IP addresses of the units scanned.
(5) Subnet mask
Displays the subnet mask to be set for the units
scanned.
(6) Default gateway
Displays the default gateway to be set for the
units scanned.
(7) Web port
Displays the port number of the web server.
(8) Name
Displays the names of the units scanned.
Note
When selecting a unit, tick the leftmost checkbox in the scanned unit list.