Attaching feed cover, Attaching darning and embroidery foot, Screw – SINGER 2210 Athena User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Attaching Feed Cover

I'or darning and free molion embroidery, the

feed cover prevents the feed from moving


material. Attach ft as follows:

♦ Raise needle and presser foot, and open

slide plate.

♦ Slide feed cover on top of needle plate,

pressing tabs (1) and (2) into holes in
needle plate. Then, close slide plate.


® To remove, open slide plate. Lift frord

edge of cover (3) and pull it away.

If operator prefers to do these operations by
removing presser foot and shank from
machine, be sure presser bar is lowered to

maintain proper thread tension.

Attaching Darning and Embroidery Foot

A Special presser foot is included as an ac-
cessory for use In darning, embroidery, and
machine basting. Attcich it to the machine
as follov/s:

♦ Raise presser bar (1) and remove existing

presser foot with attached shank follov/-
ing directions under “Changing Screw on
Presser Feet'L

♦ Wi th need I e I n t h e u p pos i t i on, g u i de dar*

ning and ernbroidety foot (2) onto presser
bar from the rear of the machine, hook-
ing it around the bar (1) and under the
screv^ (3).

♦ Make sure tab (4) of foot is fitted on top

of the needle clamp screw (5). This pro­
vides the automatic lifting of the foot for
manual positioning of the fabric when
needle is in the “up” position and out of


♦ Tigtiten


(3) snugly using a coin.

This manual is related to the following products: