Threading the bobbin case – SINGER 2210 Athena User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Threading the Bobbin Case
* Hold bobbin so that thread unwinds in a
counter-clockwise direction, as shown,
and place bobbin in bobbin case (1),
• Pull thread into notch (2), draw it back
under the tension spring (3), and back in
to slot (4).
Draw approximately 4 inches (10 cm) of
thread across the bobbin.
Close slide plate allowing the thread to
enter the slot between the needle plate
and slide plate.
11
Advertising
This manual is related to the following products: